Ryobi P600 manual Optional Woodworking Sub-Base, Operation, Trimmer Handles, See Figure, Workpiece

OPERATION

OPTIONAL WOODWORKING SUB-BASE

Turn the P600 laminate trimmer into a trim router with the op- tional woodworking sub-base, Ryobi Part No. 200334001.

The woodworking sub-base accessory with handles is con- venient when routing 4 in., 5 in., or 6 in. circular grooves. It can also be used when routing grooves parallel to the edge of the workpiece or with ball-bearing piloted bits.

The handles allow you to grasp and hold the trimmer with two hands, similar to grasping and holding a router.

This trimmer is designed for roundover and other edging operations up to 3/8 in. It is also useful for rabbeting or dado operations with straight bits up to a maximum diameter of 1/4 in.

WARNING:

Do not use straight bits larger than 1/4 in. or edging bits which cut a pattern larger than 3/8 in. with this trimmer. Use of larger bits can result in loss of control and serious personal injury.

TRIMMER

HANDLE(S)

WARNING:

Always use the laminate sub-base for laminate trimming. Always use the woodworking sub-base for trim routing operations. Use of the trimmer without a sub-base or us- ing the incorrect sub-base can result in serious personal injury.

R	3	2
	R		1	R	2
		2

WOODWORKING

SUB-BASE

ACCESSORY

SUB-BASE

SCREW(S)

			/
			1	4
		/
		1	2
	/
1	3	4

Fig. 10

WARNING:

Never install a bit larger than the opening of the trimmer base. The use of larger bits can result in loss of control and possible serious personal injury.

ATTACHING THE WOODWORKING SUB-BASE ACCESSORY AND HANDLES

See Figure 10.

nTurn the switch to OFF and remove the battery pack from the trimmer.

nTurn the trimmer upside down to remove the four sub- base screws and laminate sub-base.

nAttach the woodworking sub-base accessory using the same four screws.

nTighten the screws securely. Do not overtighten.

nTurn the trimmer upright and thread the handles provided into the threaded holes in the woodworking sub-base accessory.

nTighten the handles securely. Check often to assure the handles remain securely tightened.

ROUT CIRCULAR GROOVE CLOCKWISE

FINISHING	R	3	R	1		2
			2		R
NAIL			2

1/4 1/2 3/4 1

WORKPIECE Fig. 11

14