Ryobi P600 manual Operation, Applications, Installing The Battery Pack, Removing The Battery Pack

Models: P600

1 62
Download 62 pages 29.65 Kb
Page 10
Image 10
OPERATION

OPERATION

WARNING:

Do not allow familiarity with tools to make you care- less. Remember that a careless fraction of a second is sufficient to inflict serious injury.

APPLICATIONS WARNING:

Always wear safety goggles or safety glasses with side shields when operating tools. Failure to do so could re- sult in objects being thrown into your eyes, resulting in possible serious injury.

APPLICATIONS

You may use this tool for the following purposes:

Smooth, professional trimming of laminates and wood veneer

When used with the optional woodworking sub-base with handles, this tool may be used for the following light-duty applications:

Routing grooves and shaping edges in wood

Chamfering, rabbeting, dadoing, and dovetailing in wood

Routing edges on plastic laminates

This product will accept Ryobi One+ 18 V lithium-ion battery packs and Ryobi One+ 18 V nickel-cadmium battery packs.

For complete charging instructions, refer to the Operator’s Manual for the battery packs and chargers listed in the General Safety Rules.

INSTALLING THE BATTERY PACK

See Figure 5.

NOTE: The battery pack is shipped in a low charge condi- tion. Therefore, it must be charged prior to use. Refer to page 11, “CHARGING THE BATTERY PACK” for charging instructions.

nPlace the battery pack in the trimmer. Align the raised rib on the battery pack with the groove inside the trimmer, then slide the battery pack into the trimmer.

INSTALLING THE BATTERY PACK WARNING:

Always be sure the switch is in the OFF position before installing the battery pack. Failure to do so could cause accidental starting, leading to serious personal injury.

nMake sure the latches on each side of your battery pack snap into place and the battery pack is secured in the trimmer before beginning operation.

DEPRESS LATCHES TO REMOVE BATTERY PACK

BATTERY

PACK

REMOVING THE BATTERY PACKManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundLATCH

Fig. 4

CAUTION:

When placing battery pack in the tool, be sure raised rib on battery pack aligns with the bottom of the tool and latches into place properly. Improper installa- tion of the battery pack can cause damage to internal components.

REMOVING THE BATTERY PACK

See Figure 4.

nLocate the latches on the side of the battery pack and depress them to release the battery pack from the trim- mer.

nTurn the switch to OFF and remove the battery pack from the trimmer.

10

Page 10
Image 10
Ryobi P600 manual Operation, Applications, Installing The Battery Pack, Removing The Battery Pack, See Figure