XP SBC HC
Controls | Installation |
Kit contents
This FM transmitter system consists of the following accessories:
1 x SBC HC8372 FM transmitter
1 x SBC CS030/00 12Volt / 200mA AC/DC adapter (for UK: SBC CS030/05 12 Volt/ 200 mA AC/DC adapter)
1 x 3.5 mm stereo plug to 2x RCA audio cable (15 cm)
1 x 3.5 mm plug to 6.3 mm stereo adapter plug
1 x antenna tube
Controls
Transmitter (figure 1)
1Power indicator – lights up when audio signals are detected at the audio input.
2DC power – connect to the 12 Volt/ 200 mA AC/DC adapter
33.5 mm stereo transmitter audio input – the audio cable connects your FM transmitter to an audio source
4Channel switch – select one of
2 channels for best reception. We advise you to select channel 1 as a first option.
5Controls plate
Transmitter power supply
IMPORTANT
Use only Philips SBC CS030/00
12 Volt/200 mA AC/DC adapter.
(For UK, use only Philips SBC CS030/05)
1Make sure the adapter’s rated voltage corresponds to the mains socket voltage.
2Connect the DC connector of the AC/DC adapter to the 12 Volt DC power input connector located at the rear of the transmitter.
3Connect the 12 Volt/200 mA AC/DC adapter to the mains socket.
–Always disconnect the AC/DC adapter if the transmitter is not to be used for a long period of time.
4Insert the antenna tube in the hole, located on the top of the transmitter. Ensure that the wire which is hanging out of that hole, is guided in the antenna tube.
–Installing the antenna tube correctly, will improve the transmission range.
English
Environmental Information
All redundant packing material has been omitted.We have done our best to make the packaging easily separable into two materials: cardboard and polyethylene
Your unit consists of materials which can be recycled if disassembled by a specialized company. Please observe the local regulations regarding the disposal of packing materials, exhausted batteries and old equipment.
5
