XP SBC HC
Troubleshooting
If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or service centre.
WARNING: Under no circumstances should you try to repair the set yourself, as this would invalidate the warranty.
Problem | Remedy | |
|
|
|
No sound | – Check if the AC/DC adapter is fully inserted into the | |
| AC outlet and that its DC connector is properly inserted | |
| into the 12 Volt DC input connector located at the rear | |
| of the transmitter. | |
| – Check if the audio source is switched on and tuned to | |
| a channel with audio. | |
| – Volume not adjusted. Adjust the volume on the audio | |
| source/ transmitter to a higher level. | |
| – Change the transmitter’s tuning frequency. Select one | |
| of the 2 channels for best reception. We advise you to | |
| select channel 1 as a first option. | |
|
|
|
Distorted sound | – Distance from the transmitter is too large. | |
| Move closer to the transmitter. | |
| – Interference from fluorescent lamps/ other radio | |
| sources. Move transmitter elsewhere/ change the | |
| transmitter’s channel. | |
|
|
|
Maintenance | – Do not leave the transmitter near heat sources. | |
| Do not expose to direct sunlight, excessive dust, | |
| moisture, rain or any kind of mechanical shock. | |
| – Do not use alcohol, thinner or | |
| substances to clean the transmitter. Use a slightly | |
| dampened chamois cloth to clean the housing. | |
| – Do not use cleaning agents containing alcohol, spirits, | |
| ammonia or abrasives as these may harm the housing. |
English
7