17
ProblemSolution
Type HD7826/HD7824 only: the
Water leaks from the coffee machine.
The coffee spout cannot be taken out of the machine.
The lid cannot be opened.
The coffee machine produces less coffee than before.
there is enough water in the water reservoir (i.e. above the q MIN level if you want to brew 1 cup);
the ambient temperature is not lower than 50cF / 10cC. If it is, the machine will not function properly.
Make sure that there is enough water in the water reservoir for brewing 2 cups of coffee. If the light ring around the
Make sure that:
the lid is properly closed (the lever must be properly locked);
the water reservoir has not been filled beyond the MAX level;
the sieve in the centre of the pod holder is not clogged. If it is, unclog the sieve by holding the pod holder under a running tap. If necessary, you can use a soft dish brush or a pin to unclog the sieve;
the coffee pod has been put properly in the centre of the pod holder;
the sealing ring has not got stuck under the edge of the water distribution disc..
the water drops on the worktop are not the result of placing or removing the water reservoir or removing used coffee pods.
you do not remove the water reservoir when the coffee machine is heating up.This may cause water that normally ends up in the water reservoir to leak out of the machine.
In all other cases, contact the Philips Norelco Service Location.
The coffee spout can only be taken out after the coffee collector has been removed.
A vacuum may have temporarily formed under the lid.
Switch the machine off. Pull the lever up as far as it will go and wait
24 hours before opening the lid.You may need to use quite some force.
Make sure that the sieve in the centre of the pod holder is not clogged. If it is, unclog the sieve by holding the pod holder under a running tap. If necessary, you can use a soft dish brush or a pin to unclog the sieve.
If problems continue to occur, contact the Philips Norelco Service Location.
Perhaps the sieve in the centre of the pod holder is clogged. If this is the case, unclog the sieve by rinsing the pod holder under a running tap. Use a soft dish brush to clean the sieve, if necessary.
Descale the machine (see chapter ‘Descaling’).
