Philips HX6710 English, Cord wrap on deluxe charger select models, Cleaning, Toothbrush handle

10ENGLISH

Cord wrap on deluxe charger (select models)

If your model includes the deluxe charger cover and base, the travel charger is pre-installed inside the cover. If you want to shorten the power cord, you can store excess cord in the cord wrap feature built into the charger base.

1To separate the charger cover from the charger base, press the two gray snap bars on the charger base and pull the white charger cover

upwards.

2 Wrap excess power cord around the gray charger base as shown in the picture. Be sure to wrap the cord on the inside of the two snap levers.

3 When you have stored the excess cord, guide the power cord through the small groove in the rear of the gray charger base.

4Reattach the charger cover by pressing it down over the charger

base until it snaps into place.

Tip: For extra convenience during travel, you can remove the travel charger and use it without the charger cover and charger base.

Cleaning

Do not clean brush heads, handle, charger or charger covers in the dishwasher.

Toothbrush handle

1 Remove the brush head and rinse the metal shaft area with warm water.

Do not push on the rubber seal on the metal shaft with sharp objects, as this may cause damage.

2Use a damp cloth to wipe the entire surface of the handle.