Philips HX6910 manual Quadpacer, Cord wrap on deluxe charger select models

English 9

Quadpacer®

1

2

4 3

-- The Quadpacer® is an interval timer that has a short beep and pause to remind you to brush the 4 sections of your mouth. Depending on the brushing mode or brushing routine you have selected, the Quadpacer beeps at different intervals during the brushing cycle.

See the “Brushing instructions” and “Personalizing your brushing experience” sections.

The Quadpacer feature on this model has been activated.To deactivate or reactivate the Quadpacer feature:

1Place the handle with a brush head attached in the plugged-in charger.

2Press and hold the Personalized brushing button until:

AYou hear 1 beep to indicate the Quadpacer has been deactivated. B You hear 2 beeps to indicate the Quadpacer has been activated.

Note:The Quadpacer feature cannot be deactivated on the pre-programmed Go Care and Max Care brushing routines.

Cord wrap on deluxe charger (select models)

If your model includes the deluxe charger cover and base, the travel charger is pre-installed inside the cover. If you want to shorten the power cord, you can store excess cord in the cord wrap feature built into the charger base.

1To separate the charger cover from the charger base, press the two gray snap bars on the charger base and pull the white charger cover upwards.

2Wrap excess power cord around the gray charger base as shown in the picture. Be sure to wrap the cord on the inside of the two snap levers.

3When you have stored the excess cord, guide the power cord through the small groove in the rear of the gray charger base.

4Reattach the charger cover by pressing it down over the charger base until it snaps into place.

Tip: For extra convenience during travel, you can remove the travel charger and use it without the charger cover and charger base.

4235.020.2275.6.indd 9

29-09-09 09:21