VEHICLE PREPARATION
1.Read the manual and get familiar with the product requirements and connections.
2.Install the headrests.
a.Remove vehicle’s original headrests and store in a safe place.
b.Locate the box of tube adapters and find the tubes that match the diameter of your factory headrest post. There are six different sizes: 12mm, 12.5mm, 12.7mm, 13.8mm, 14mm, and 16mm
The chart lists standard post sizes for different vehicle makes. Insert appropriate support tube adaptors in vehicle post guides. (if needed).
Vehicle | Factory Post |
| Option Sizes |
Ford/Lincoln | 10 mm, 12 mm and 12.7 mm |
Nissan/Infiniti | 12.7mm |
Toyota/Lexus | 12 mm and 13.88 mm |
Honda/Acura | 10 mm and 12.7 mm |
Chrysler/Dodge | 10 mm, 12 mm, and 12.7 mm |
GM/Chevrolet | 10 mm, 11 mm, 12 mm and 14 mm |
Locate an accessory power source (+12VDC present when the ignition key is in the accessory and run positions. 0VDC should be present when the ignition key is in the OFF position). (Refer to the Wiring Diagrams on page 9. Be sure, that all the wiring is protected from sharp edges and is routed in such a manner that it will not be pinched, when it is fully installed.
3. Plug the power adapter into the accessory socket.
7
