Kvaser LAPcan / LAPcan II Hardware Guide | 11(19) |
|
|
7 A Few Words of Caution
∙Do not apply excessive force when inserting the card into the computer.
∙Do not remove the card by pulling on the I/O cables.
∙Always make sure the I/O connectors are firmly seated.
∙When you remove a DRVcan, you must firmly press both the tabs (see Figure 3 below) on the connector.
Figure 3. The I/O connector on a DRVcan. The tabs are marked with arrows.
The D-SUB connector
Figure 4. The DSUB connector on a DRVcan.
The CAN bus is connected to the 9-pin DSUB connector (see Figure 4 above) on the DRVcan.
Kvaser AB, Mölndal, Sweden — www.kvaser.com
