Connections
English
Step 1: Placing speakers and
subwoofer |
Step 2: Connecting speakers and subwoofer
ANTENNA |
FM |
(75Ω) |
For best possible surround sound, locate your speakers and subwoofer as follows:
●Place the left and right speakers at equal distances from the TV set and at an angle of approximately 45 degrees from the listening position.
●Place the subwoofer on the floor near the TV set.
Notes:
–To avoid magnetic interference, do not position the left and right speakers too close to your TV set.
–Allow adequate ventilation around the DVD System.
IMPORTANT!
The type plate is located on the bottom of the system.
To avoid overheating of the system, a safety circuit has been built in. Therefore, your system may switch to Standby mode automatically under extreme conditions. If this happens, let the system cool down before reusing it.
●Connect the supplied DIN cable to DVD player’s DIN jack and the left speaker’s DIN jack.
●Connect the supplied speaker wires of the right speaker to SPEAKER RIGHT on the left speaker, red wire to red jack ( “+” ), black wire to black jack (
●Connect the supplied speaker wire of the subwoofer to SUBWOOFER OUT on the left speaker, green wire to green jack ( “+” ), white wire to white jack (
●Connect the supplied AC power cord to AC MAINS of the left speaker and the wall socket.
Notes:
–For optimal sound performance, use the supplied speakers.
–Do not connect more than one speaker to any one pair of +/- speaker terminals.
–Do not connect speakers with an impedance lower than the speakers supplied. Please refer to the SPECIFICATIONS section of this manual.
6
