39
English
Clock/Timer

Clock setting

See "Preparations-Step 2: Setting the clock".

Timer setting

●The system can be used as an alarm clock,
whereby the last selected source is switched on
at a set time (one time operation). The clock
time needs to be set first before the timer can
be used.
1In standby mode, press and hold SLEEP/
TIMER for more than three seconds.
➜"TIMER SET" is displayed briefly. Then, the
hour digits flash on the display panel.
2Press VOLUME -/+ (VOL +/- on the remote)
to set the hours and SLEEP/TIMER to
confirm.
➜The minute digits flash on the display panel.
3Press VOLUME -/+ (VOL +/- on the remote)
to set the minutes and SLEEP/TIMER to
confirm.
➜"TUN", “DVD” or "USB" flashes.
4Press VOLUME -/+ (VOL +/- on the remote)
to select your desired source.
5Press SLEEP/TIMER to complete the setting.
➜Display shows .
To deactivate the timer
●Press SLEEP/TIMER again.
➜ disappears.

Sleep timer setting

The sleep timer enables the system to switch off
by itself after a set period of time.
1Press SLEEP/TIMER on the remote control
repeatedly to select a preset time.
➜The selections are as follows (time in
minutes):
OFF ™ 15 ™ 30 ™ 45 ™ 60 ™ 75 ™ 90 ™
105 ™ 120 ™ OFF
➜"SLEEP XX" or "SLEEP OFF" is displayed.
"XX" is the time in minutes.
2When you reach the desired length of time, stop
pressing SLEEP/TIMER.
➜Display shows .
To deactivate the sleep timer
●Press SLEEP/TIMER repeatedly until "00" is
displayed, or press STANDBY-ON y
(STANDBY y on the remote).
➜ disappears.
pg025-pg044_MCD288-22-Eng-B 2006.3.10, 17:1639