Philips MCI300 quick start Lead not simply over the two wires

JProtect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and the point where they exit from the apparatus.

KOnly use attachments/accessories specified by the manufacturer.

LUse only with the cart, stand, tripod, bracket, or table specified by the manufacturer or sold with the apparatus.When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over.

MUnplug this apparatus during lightning storms or when unused for long periods of time.

NRefer all servicing to qualified service personnel.

Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.

OBattery usage CAUTION – To prevent battery leakage which may result in bodily injury, property damage, or damage to the unit:

•Install all batteries correctly, + and - as marked on the unit.

•Do not mix batteries (old and new or carbon and alkaline, etc.).

•Remove batteries when the unit is not used for a long time.

p�Apparatus shall not be exposed to dripping or splashing.

q�Do not place any sources of danger on the apparatus (e.g. liquid filled objects, lighted candles).

r�This product may contain lead and mercury. Disposal of these materials may be regulated due to environmental considerations. For disposal or recycling information, please contact your local authorities or the Electronic Industries Alliance: www. eiae.org.

Warning

•Never remove the casing of this MCi300.

•Never lubricate any part of this MCi300.

•Place this MCi300 on a flat, hard and stable surface.

•Never place this MCi300 on other electrical equipment.

•Only use this MCi300 indoors. Keep this MCi300 away from water, moisture and liquid-filled objects.

•Keep this MCi300 away from direct sunlight, naked flames or heat.

How to connect a plug

The wires in the mains lead are coloured with the following code: blue = neutral (N), brown = live

(L).

As these colours may not correspond with the colour markings identifying the terminals in your plug, proceed as follows:

•Connect the blue wire to the terminal marked N or coloured black.

•Connect the brown wire to the terminal marked L or coloured red.

•Do not connect either wire to the earth terminal in the plug, marked E (or e) or coloured green (or green and yellow).

Before replacing the plug cover, make certain that the cord grip is clamped over the sheath of

the lead - not simply over the two wires.

Mains plug

This apparatus is fitted with an approved 13 Amp plug.To change a fuse in this type of plug proceed as follows:

ARemove fuse cover and fuse.

BFix new fuse which should be a BS13625 Amp, A.S.T.A. or BSI approved type.

CRefit the fuse cover.

If the fitted plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place.

If the mains plug contains a fuse, this should have a value of 5 Amp. If a plug without a fuse is used, the fuse at the distribution board should not be greater than 5 Amp.

The severed plug must be disposed off to avoid a possible shock hazard should it be inserted into a 13 Amp socket elsewhere.

Norge

Typeskilt finnes på apparatens bakside. Observer: Nettbryteren er sekundert innkoplet. Den innebygde netdelen er derfor ikke fraktoplet nettet så lenge apparatet er tilsluttet nettkontakten.

For å redusere faren for brann eller elektrisk støt, skal apparatet, ikke utsettes for regn eller fuktighet.

en

11