AUX | Timer |
AUX (Listening to an external source)
You can listen to the sound of the connected external device through your MCM760
1Check the external device has been properly connected (See Installation, Connecting an additional appliance)
2Press TAPE/AUX once or more to select AUX (or AUX on the remote control)
3To avoid noise distortion, turn down the volume on your external device
4Press the PLAY key on the connected device to start playback
5To adjust the sound and volume, use the sound controls on your external device and the MCM760
Setting the timer
The set can be used as an alarm clock, whereby the selected source (CD,TUNER, USB or TAPE) starts playback at a preset time. Make sure the clock is set before using the timer.
IMPORTANT!
–if recording is in progress, the timer function will not be activated.
–The volume of the timer will increase gradually to the last tuned volume level. If the last tuned volume level is too low, the set will then increase to a predetermined minimum audible level
1 On the remote control, press and hold
SLEEP/TIMER
➜ icon starts flashing
2Select the timer source: CD, TUNER, USB or
TAPE
➜ The selected source lights up
3Press à or á repeatedly to set the hour
4Press ÉÅto change to minutes setting, then press à or á repeatedly to set the minutes
5Press SLEEP/TIMER to store the setting
➜ icon stops flashing.The timer is now set and activated
➜At the set alarm time, the CD,TUNER, USB or TAPE will switch on and after 30 minutes switch to ECO POWER automatically
Note:
–The set will exit from the timer setting mode if no button is pressed within 90 seconds.
English
31