Philips MME-100 warranty Specifications, Troubleshooting, Problem, Solution, English

Specifications

English

AMPLIFIER

Output power ... 2 x 5 W RMS / 2 x 5 W FTC(1)

.................................................................		10 W total power
Signal-to-noise ratio		≥ 62 dBA (IEC)
Frequency response	60 – 16000 Hz, ± 3 dB
Input sensitivity AUX		0.5 V (max. 2 V)
Impedance loudspeakers	.........................................		3 Ω
Impedance headphones		32 Ω	-1000 Ω
(1) (3 Ω , 200 Hz- 12.5kHz, 10% THD)
CD PLAYER
Number of programmable tracks			30
Frequency range		63 – 14 KHz
Signal-to-noise ratio			62 dBA
Channel separation		≥ 30 dB (1 kHz)
Total harmonic distortion			< 1.5 %
TUNER
FM wave range		87.5 – 108 MHz
AM wave range		530 – 1700 kHz
Sensitivity at 75 Ω
– mono, 26 dB signal-to-noise ratio			≤ 22 dBu
– stereo, 46 dB signal-to-noise ratio			61.4 µV

TAPE DECK
Frequency response
Normal tape (type I)	80 – 10000 Hz (8 dB)
Signal-to-noise ratio
Normal tape (type I)	48 dBA
Wow and flutter	≤ 0.35% DIN

SPEAKERS

2-way Bass reflex system

Dimensions (w x h x d)148 x 221.5 x 175 (mm)

..................................................	5.83 x 8.72 x 6.89 (inch)
GENERAL INFORMATION
AC Power	120 V / 60 Hz

Dimensions (w x h x d)154 x 225.5 x 215 (mm)

.................................................. 6.06 x 8.88 x 8.46 (inch)

Weight (with/without speakers) ..................................

............................................................... approx. 6.3 / 3.3 kg

............................................. approx. 13.86 / 7.26 pound

Standby power consumption < 3 W

Specifications and external appearance are subject to change without notice.

Troubleshooting

WARNING

Under no circumstances should you try to repair the system yourself, as this will invalidate the warranty. Do not open the system as there is a risk of electric shock.

If a fault occurs, first check the points listed below before taking the system for repair. If you are unable to remedy a problem by following these hints, consult your dealer or service center.

Problem		Solution
CD OPERATION
	“nO dISc” is displayed.	– Insert a disc.
		– Check if the disc is inserted upside down.
		– Wait until the moisture condensation at the lens
		has cleared.
		– Replace or clean the disc, see “Maintenance”.
		– Use a finalized CD-RW or CD-R.

20