TROUBLESHOOTING TABLE

WARNING: Always stop unit and disconnect spark plug before performing all of the recommended remedies below except remedies that require operation of the unit.

 

TROUBLE

CAUSE

REMEDY

 

Engine will not

1.ON/OFF switch in OFF

1.

Move ON/OFF switch to the ON

 

start or will run

 

position.

 

position.

 

only a few

2. Engine flooded.

2.

See “Difficult Starting” in

 

seconds after

 

 

 

Operation Section.

 

starting.

3. Fuel tank empty.

2.

Fill tank with correct fuel mixture.

 

 

4. Spark plug not firing.

3.

Install new spark plug.

 

 

5. Fuel not reaching

4.

Check for dirty fuel filter; replace.

 

 

 

carburetor.

 

Check for kinked or split fuel line;

 

 

 

 

 

repair or replace.

 

 

6.Compression low.

5.

Contact an authorized service dealer.

 

Engine will

1.

Carburetor requires

1.

See “Carburetor Adjustment” in

 

not idle

 

adjustment.

 

Service and Adjustments Section.

 

properly.

2.

Crankshaft seals worn.

2.

Contact an authorized service dealer.

 

 

3.

Compression low.

3.

Contact an authorized service dealer.

 

 

 

 

 

 

Engine will not

1. Air filter dirty.

1.

Clean or replace air filter.

 

accelerate,

2. Spark plug fouled.

2.

Clean or replace plug

 

lacks power,

 

 

 

and regap.

 

or dies under

3. Carburetor requires

3.

Contact an authorized service dealer.

 

a load.

 

adjustment.

4.

Contact an authorized service dealer.

 

 

4. Carbon build up.

 

 

5. Compression low.

5.

Contact an authorized service dealer.

 

Engine

1.

Choke partially on.

1.

Adjust choke.

 

smokes

2.

Fuel mixture incorrect.

2.

Empty fuel tank and refill with

 

excessively.

 

 

 

correct fuel mixture.

 

 

3.

Air filter dirty.

3.

Clean or replace air filter.

 

 

4.

Carburetor requires

4.

Contact an authorized service dealer.

 

 

 

adjustment.

 

 

 

Engine runs

1.

Fuel mixture incorrect.

1. See “Fueling Engine” in Operation

 

hot.

 

 

 

section.

 

 

2.

Spark plug incorrect.

2. Replace with correct plug.

 

 

3.

Carburetor requires

3. Contact an authorized service dealer.

 

 

 

adjustment.

 

 

 

 

4.

Carbon build-up.

4. Contact an authorized service dealer.

 

Blade turns at

1. Carburetor requires

1. See “Carburetor Adjustment” in

 

idle speed.

 

adjustment.

 

Service and Adjustments Section.

 

 

2. Throttle cable binding.

2. Replace or repair throttle cable.

 

 

3. Clutch requires repair.

3. Contact an authorized service dealer.

 

Blade stops un-

1. Blade not engaged.

1. Check gearbox.

 

der a load or

2. Carburetor requires

2. Contact an authorized service dealer.

 

does not turn

 

adjustment.

3. Contact an authorized service dealer.

 

when engine is

3. Clutch requires repair.

 

accelerated.

 

 

 

 

11

Page 11
Image 11
Weed Eater 545117552 instruction manual Troubleshooting Table Cause Remedy