Philips PPX1230 Initial Operation, Connect power supply / charge battery, Initial Installation

EN

3 Initial Operation

Connect power supply / charge battery

CAUTION!

Mains Voltage at the Site of Installation!

Check whether the mains voltage of the power supply matches the mains voltage avail- able at the setup location.

1Insert the small plug of the power supply into the socket on the rear side of your device.

2Plug the power supply into the mains.

3During the charging process, the indicator light on the top of the device will be red. When the battery is fully charged, it will turn green.

4Charge the built-in battery before using for the first time for at least 3 hours. This will prolong, the life of the battery.

Initial Installation

1Switch the device on using the on/off switch on the side.

2Turn the device towards an appropriate projection surface or wall at a distance of at least 0,2m and at most 3m. Make sure the projector is in a secure position.

3Use the focus wheel on the top to adjust the image sharpness.

4Select the desired menu language using ¡/¢.

5Confirm with à.

Notice

The language selection does not ap- pear

The device has already been installed. In order to change the menu language, pro- ceed as follows:

1Press à.

2Select using ¡/¢ Language.

3 Confirm using à.

4 Select the desired language with ¡/¢.

5 Confirm with à.

6 You can exit with ¿.

6 Philips · PPX1230