Philips PR0930X4 warranty Hooking UP Your TV ANTENNA/CABLE Connections, Separate UHF/VHF, Antenna

PR0930x4 3/1/02 10:21 AM Page 2

HOOKING UP YOUR TV (ANTENNA/CABLE CONNECTIONS)

ANTENNA

COMBINATION UHF/VHF

Acombination antenna or a rod antenna (supplied)

receives normal broadcast channels (VHF 2-13 and UHF 14-69). Your connection is easy since there is only one 75Ω (ohm) antenna jack on the back of your TV - and that’s where the antenna goes.

If you install a rod antenna (supplied), push the base of the antenna into the antenna hole on either the left or the bottom of the TV.

If your antenna has a round connector (75Ω ), then you're ready to connect it to the TV. Go to step 2.

If your antenna has flat twin-lead wire (300Ω ), you first need to attach the antenna wires to the screws on a 300 to 75Ω adapter (not supplied).

Push the round end of the adapter (cable or rod antenna) onto the ANT(enna) IN jack on the back of the TV. If the round end of the adapter or cable is threaded, screw it down tight.

Rod Antenna

(supplied)

If you installed a rod antenna, extend the antenna and adjust its length, direction, and angle for the clearest pic- ture.

SMART

HELP

To set the TV to select only the channel num- bers in your area, see Auto Install on page 5.

If you install the TV beneath a kitchen cabinet, you may push a rod antenna into the antenna hole on the bottom of the TV cabinet for the best use. See page four for details on how to install the TV under a

Round cable of

Rod Antenna

to ANT. IN

OR 300 to 75Ω adapter to ANT. IN

Combination
VHF/UHF Antenna	Twin-lead wire
(outdoor or indoor)

OR Round Cable 75Ω to ANT. IN

To either

Antenna Hole

ANT. IN

AC 120V

kitchen cabinet.

Back of TV

SEPARATE UHF/VHF

You may have two separate antennas. One antenna is

for VHF channels (2-13) and the other antenna is for UHF channels (14-69).

For homes with separate UHF/VHF antennas, you will need an optional combiner before you can connect the antennas to the TV.

Outdoor UHF Antenna

(Twin-lead 300Ω )

Outdoor VHF

Antenna

(Twin-lead 300Ω )

Attach the separate
	Push the round end of the
UHF and VHF antennas to	combiner onto the ANT(enna)
the correct screws on the	IN jack on the back of the TV.
combiner (not supplied).

UHF/VHF Combiner	Round
(not supplied)
	End

Twin-lead
Wire	U
	HF
	300Ω
	VHF

OR

				R
				E
				T
				P
				A
				D
			Ω	A
		300
				AC 120V
		-
		75
Outdoor VHF				75-300ΩAdapter
Antenna
(Round cable 75Ω	)			Back of TV

ANT. IN

- 2 -