PR0930x4 3/1/02 10:21 AM Page 4
HOOKING UP YOUR TV (ANTENNA/CABLE CONNECTIONS) (CONT’D)
CABINET INSTALLATION / INSTALLATION SUR UN MEUBLE
SMART HELP
CABINET INSTALLATION
INSTALLATION SUR UN MEUBLE
Follow the instructions below to install the TV beneath a
kitchen cabinet.
Suivre les instructions
téléviseur en-dessous d’un meu- ble de cuisine.
Drill six
Percer six trous de 1/4 de pouce dans le dessous du meuble en se guidant à l’aide des six cercles sur la base pivotante (fournie).
Attach the swivel base to the cabinet using six of each of the following: screws, washers, and hexagonal nuts (supplied). Refer to the draw- ing shown below.
Fixer la base pivotante au meuble à l’aide des six vis, rondelles et écrous hexago- naux (fournis). Référez vous au dessin ci dessous.
Slide the TV onto the hook on the swivel base and push it backward until the TV locks into place.
Faire glisser le téléviseur sur le crochet de la base pivotante et le repousser jusqu’à ce que le téléviseur se verrouille en place.
Secure the TV to the swivel base using two
Make sure 
the area directly beneath the TV is not used for cook- ing and does not contain an appliance that generates heat or steam.
Veiller à ce que la zone directement
3/16"(5mm) x 1-9/16"(40mm) Screw (Vis)
Washer 
(Rondelle)
5/32”(4mm) x 11/16”(18mm) screws (supplied).
Fixer le téléviseur sur la base pivotante à l’aide de deux vis de 5/32”(4mm) x 11/16”(18mm) (fournies).
enne pas d’appareils générateurs de chaleur ou de vapeur.
Hexagonal Nut 
(Ecrou hexagonal)
5/32"(4mm) x 11/16"(18mm) Screws (Vis)
Swivel Base 
(Base pivotante)
TV
(Téléviseur)
Cabinet Installation
•Keep in mind your normal work pattern, especially the way in which you use other electrical appliances, when you are thinking about where to install the TV.
•Hold the TV in various locations. In each location, turn the TV on so you may check reception.
•If you are going to use the rod antenna, allow enough space around the TV to extend and adjust the antenna.
•Make sure the TV is close enough to an electrical outlet that the power cord can reach it.
•Allow enough room on all sides of the TV for ventilation, access to control knobs, and room to swivel the TV for ease of viewing.
•Route and arrange the excess AC cord so that it will not drape where it can be pulled on or tripped over unintentionally.
CAUTION: To reduce the risk of fire, do not place any heating or cooking appliances beneath this unit.
ATTENTION: Afin de réduire les risques d’incendie, ne placer aucun appareil chauffant ou de cuisson
NOTE: Screws that are too short will not screw far enough into the nuts to securely hold the TV. Screws that are too long will protrude below the base of the cabinet and may scratch the TV when it is swiveled.
REMARQUE: Des vis trop courtes ne se visseront pas suffisamment profondément dans les écrous pour maintenir le téléviseur en toute sécurité. Des vis trop longues dépasseront de la base du meuble et pourront rayer le téléviseur lorsque il pivotera.
NOTE: Route and arrange the excess AC cord as illustrated at right so it will not drape where it can be pulled on or tripped over.
REMARQUE: Acheminer et arranger le cordon CA en excès, comme montré dans l’illustration, de telle sorte qu’il ne puisee pas être tiré ou accroché.
Wire Tie
Power Cord (Cordon d’alimentation)
AC 120V
ANT. IN
USING THE FRONT AUDIO/VIDEO IN JACKS
SMART HELP
AUDIO/VIDEO IN JACKS
For more convenient tape playback from a camcorder
or VCR, use the AUDIO and VIDEO In jacks on the front of the TV. These easily accessible jacks allow quick connections between the TV and the VCR or camcorder.
Connect a video |
| Connect an audio cable |
cable (not supplied) to the |
| (not supplied) to the |
VIDEO OUT jack of the |
| AUDIO OUT jack of the |
camcorder/VCR and to the |
| camcorder/VCR and to the |
yellow VIDEO In jack on |
| white AUDIO In jack on |
the front of the TV. |
| the front of the TV. |
|
|
|
AUDIO VIDEO | MENU | VOLUME |
EARPHONE
VIDEO AUDIO
OUT
Audio Cable (white) from
AUDIO OUT to AUDIO
Video Cable (yellow) from
VIDEO OUT to VIDEO
When you play a tape on the VCR or camcorder, select A/V IN at the TV.
Press the TV/AUX button to select A/V IN. A/V IN will appear on the screen.
Turn on the cam- corder/VCR and press the PLAY button on the cam- corder/VCR.
When you are finished watching the tape, press the STOP button on the camcorder/VCR. 
When you are 
finished watching the tape, press the TV/AUX button on the TV remote con- trol to return to viewing normal TV channels.
If the VCR or cam- corder has Right and Left AUDIO OUT jacks, you will need a “Y” connec- tor cable in order to connect the cam- corder/VCR to the TV. Or, check the owner’s manual of the camcorder or VCR. It may explain how to connect to a TV that has a sin- gle AUDIO In jack.
- 4 -
