ANT.IN
IN
OUT
OR
Your Cable TV signal may be
a single (75V) cable or a
Cable Box installation. In either
case, the connection to the TV
is very easy.
CABLE TV
CABLE/CABLE BOX If you do not have a
Cable Box, then you're ready
to connect your Cable TV sig-
nal to the TV.
If you have a Cable Box:
Connect the Cable TV sig-
nal to the IN jack on the
Cable Box.
Connect the Cable TV sig-
nal to the ANT(enna) IN
jack on the TV.
If you have a Cable Box:
Use a coaxial cable to con-
nect the OUT jack of the
Cable Box to the
ANT(enna) IN jack on the
TV.
NOTE: The coaxial cable
might be supplied by the Cable
TV company.
Back of TV
Coaxial cable
Cable Box
To select
only the channels on
your Cable system,
see First Time Setup
(page 4). If you use a
Cable Box, set the
TV to the same
channel as the CH
3/4 switch on the
back of the Cable
Box and select chan-
nels at the Cable
Box.
SMART
HELP
Cable TV Company
Cable TV Signal (75Ω)
Note to the Cable TV System Installer:This reminder is provided to
call the Cable TV system installer’s attention to Article 820-40 of the
National Electrical Code, which provides guidelines for proper grounding - in
particular, specifying that the cable ground shall be connected to the ground-
ing system of the building, as close to the point of cable entry as possible.
HOOKING UPYOUR TV (ANTENNA/CABLE CONNECTIONS) (CONT’D)
ANT.IN
ANT.IN
OUT TO TV
IN FROM ANT.
The basic Antenna/Cable to
VCR to TV connection is
shown here. If you have a Cable
Box, refer to the VCR owner’s
manual for details.
VCR TO TV
BASIC CONNECTION
Connect your
Antenna or Cable signal to
the IN FROM ANT(enna)
jack on the VCR.
Connect a coaxial
cable to the OUT TO
TV jack on the VCR
and to the ANT(enna)
IN jack on the TV.
The coaxial cable may be
supplied with the VCR.
Coaxial cable
Outdoor VHF/UHF
Antenna
300 to 75ΩAdaptor
Cable TV signal Back of TV
Refer to the VCR
owner's manual for other
possible connections and for
operating details.
VCR
- 3 -