BASIC CABLE TV SIGNAL CONNECTION
CABLE TV
Your Cable TV input into your home may be a single (75
ohm) cable, or a Converter Box installation. In either case the connection to the TV is very easy. Just put the threaded end of the cable signal to the TV's antenna plug and screw it down tight.
BEGIN
If your Cable TV signal is a sin- gle round cable (75 ohm) then
you're ready to connect to the TV.
If you have a Cable Converter
Box:
Connect the Cable TV signal to the
Cable Signal IN(put) plug on the
Converter.
Connect the Cable TV cable to the 75Ω plug on the TV.
If you have a Cable Converter Box:
Connect the OUT(put) plug from the |
|
|
|
|
|
|
|
Converter to the 75Ω plug on the TV. | 75 V |
|
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
Back of TV
Cable TV Company |
|
| 2 |
|
|
| |
| Cable TV Signal Input |
| |
|
| OR |
|
|
|
| 75 V |
| IN | OUT |
|
|
| Jack Panel | |
|
| Round Cable | |
|
|
| |
|
| 75Ω | 1 |
| Cable TV Converter |
| |
|
|
| |
| Box Connection |
|
|
SMART
HELP
Remember: 
Set the TV for the type signal you've just connected. Refer to the Cable Control on page 11 to set the TV for cable tuning.
To select only the channel numbers on your Cable system refer to the Auto Program Control on page 12. If you use a Cable Converter box, set the TV to the same channel as the converter's CH 3/4 switch (on the rear of the converter.)
5
