Philips Sound Solutions
3.3.4.4.1AC3/DTS Pass-Through
Dynamic Edge passes AC3 or DTS digital audio data from a DVD to S/PDIF OUT. This feature allows you to play a DVD on your PC using a
3.3.4.5.Preamp Slider
The Preamp Level control allows you to boost the audio signal before it passes through the amplification circuitry. To the outside world it has the same effect as the master volume has.
Caution: If you notice any distortion in the sound, lower the Preamp Slider level to eliminate the distortion.
3.3.4.6.Fader Slider
Fader controls the balance between the front and the rear speakers.
3.3.4.7.Center Slider
Center controls the level of output on the center speaker only. Use this slider to adjust the volume on the center speaker.
3.3.4.8.LFE Slider
This slider provides control for the volume level of the subwoofer.
3.3.4.9.Balance Slider
This slider allows you to balance the left and the right speakers. It affects the front and the rear speakers.
3.3.4.10. Test Button
The Test button opens a window, which allows you test your speakers one by one. Testing a speaker channel enables you to ensure that the speakers or headphones are properly connected.
The test utility displays a button for each of the possible output channels, but the number of active buttons depends on your selected output mode. Click any active speaker button to send the test sound to the corresponding speaker. See Figure 15.
The “Loop Sounds” button allows you to repeat the test sound until you click Stop. If the Loop Sounds is off, the sound will only play once for each click of a speaker button.
The Auto button sends the test sound to each speaker once and moves it to the next speaker automatically.
The Close button exits the test utility and returns you to the Main Control Panel Setup Tab.
Dynamic Edge™ Soundcard User’s Guide | 23 |
