20
2If nothing happens, recharge the battery for at least 4 hours and try to power on or reset
again. If this does not work, you might have to repair your player with Philips Device
Manager.
There is no sound.
Make sure your headphones are inserted all the way into the headphones jack.
Note The existing contents on your player will not be erased.
My player cannot power on.
• You may have failed to press and hold 2; long enough. Press and hold 2; until the Philips
welcome screen appears on display.
• Your device battery may be out of power due to long period of non-usage. Please charge
your player.
If none of the above works, then you may have to use the Device Manager to
recover your player:
1Launch the Philips Device Manager at Start > Programs > Philips Digital Audio
Player > SA28XX > Philips SA28XX Device Manager on your PC.
2Press and hold the button while your player is connecting to the PC.
3Keep holding the key until the Philips Device Manager acknowledges your player and
goes into recovery mode.
4Click the repair button and follow the instructions given by the Device Manager.
5After the player has been repaired, disconnect it from your PC and re-start.
There is no music on my player after transfer.
Are your songs in MP3 or WMA format?
Other formats will not playback on the player.
My player hangs.
1In the unlikely event that your player hangs, do not panic. Insert a small pin or other
sharp object into the reset hole located at the bottom of the player. Hold until the player
shuts down.
7 Frequently asked questionsIf you encounter problems with your player, go through the following points listed in the
next section. Please also check out FAQs at www.philips.com/support for further help and
other troubleshooting tips.
Consult your dealer or service center if you are unable to find a solution by following these
hints.
Warning Under no circumstances should you try to repair the set yourself, as this will
invalidate the warranty.