Philips SCD590 Preparing for use, Baby unit, Corded operation, Battery operation, Parent unit

English 

10Small plug

11Battery compartment lid

12Inlet for small plug

13Battery compartment

BParent unit (2 pieces, only one is shown)

1 TALK button

2 LINK light

3 SENSITIVITY button

4 On/off button 3

5 Opening for belt clip and neck strap

6 Sound level lights

7 Volume +/– buttons

8 Battery check light T

9 Microphone

10 Loudspeaker

11 Battery compartment

12 Belt clip

13 Battery compartment lid

14 Neck strap

15 Adapter

16 Charger

17 POWER light

CTravel pouch

Preparing for use

Baby unit

You can operate the baby unit directly from the power supply or on batteries. Even if you are going to operate the unit from the power supply, we advise you to insert batteries.This guarantees automatic back-up in case of power failure.

Corded operation

1Put the small plug in the baby unit and put the adapter in a wall outlet (Fig. 2).

Battery operation

The baby unit runs on four 1.5V R6 AA batteries (not included). We strongly advise you to use Philips LR6 PowerLife batteries.

Make sure your hands and the unit are dry when you insert the batteries.

1Turn the battery compartment lid to the left ( Á OPEN) with the palm of your hand. (Fig. 3)

2Remove the lid.

3Insert four 1.5V R6 AA batteries (Fig. 4).

,Place two batteries on top of each other and make sure the + and – poles of the batteries point in the right direction.

4Put the battery compartment lid back onto the unit and turn it to the right (CLOSE ª) with the palm of your hand to close it. (Fig. 5)

Note: When the batteries are running low, the battery check light ( T) lights up red.

Parent unit

This appliance comes with two parent units and two chargers instead of one, so that your baby can be monitored by two persons at the same time.