Connecting the belt clip
1 Insert the small pin on the back of the belt clip into the opening on the back of the parent
unit (1). Turn the belt clip to the left (2) until it locks into position (‘click’) (Fig. 24).
Disconnecting the belt clip
1 Turn the belt clip to the right (1) and take it out of the opening (2) (Fig. 25).
Connecting the neck strap
1 Insert the small pin at the end of the neck strap into the opening on the back of the parent
unit (1). Turn the neck strap to the left (2) until it locks into position (‘click’) (Fig. 26).
Disconnecting the neck strap
1 Turn the neck strap to the right (1) and take it out of the opening (2) (Fig. 27).
Reset function
This function allows you to reset the baby monitor to the default settings. You can use this function if
problems occur that cannot be solved by following the suggestions in chapter ‘Frequently asked
questions’. You have to reset each unit separately.
1 Press and hold the on/off button 3 for 2 seconds to turn on the unit. (Fig. 11)
2 Then immediately press and hold the volume down (-) button until the appliance
beeps. (Fig. 28)
The unit has now been reset to the default factory settings.
Now do the same for the other two units.
Default settings
Parent unit
Loudspeaker volume: 1
Microphone sensitivity: 3
Baby unit
Loudspeaker volume: 3
Nightlight: off
Cleaning and maintenance
Do not immerse the units in water and do not clean them under the tap.
Do not use a cleaning spray and/or liquid cleaners.
1 Unplug the baby unit if it is connected to the wall outlet and take the parent unit out of the
charger.
2 Clean the units with a damp cloth.
Storage
You can use the travel pouch to store the baby monitor while you travel.
When you are not going to use the baby monitor for some time, remove the batteries and
store the units and the adapters in the travel pouch supplied.
Environment
Disposal of your old product
Your product is designed and manufactured with high-quality materials and components, which can
be recycled and reused.
,
-
-
-
-
,
,
EngliSh 13