![](/images/new-backgrounds/1001350/135013x1.webp)
SHC1300_booklet
Troubleshooting
If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or service centre.
WARNING: Under no circumstances should you try to repair the set yourself, as this would invalidate the warranty.
English
Problem | Remedy | |
|
|
|
No sound | – Check if the AC/DC adapter is fully inserted | |
| into the AC outlet and that its DC connector is | |
| properly inserted into the 12 Volt DC input | |
| connector located at the rear of the | |
| transmitter. | |
| – Check if the headphone’s on/off switch is in | |
| the on position. | |
| – Headphone batteries running low. | |
| (See Headphone power supply) | |
| – Check if the audio source is switched on. | |
| – Volume not adjusted. Adjust the volume on | |
| the audio source/ headphone to a higher level. | |
| – Make use of the SHC1300 transmitter. | |
| Some transmitters already built into other | |
| equipment may not be compatible with the | |
| SHC1300 headphone because of the advanced | |
| technologies used in the SHC1300 headphone. | |
|
|
|
Distorted sound | – Headphone batteries running low. | |
| (See Headphone power supply) | |
| – Check the volume on audio source/ | |
| headphone is not set at too high a level. | |
| Reduce the volume. | |
| – Distance from the transmitter is too large. | |
| Move closer to the transmitter. | |
| – Interference from fluorescent lamps/ other | |
| radio sources. Move transmitter or headphone | |
| elsewhere. | |
| – Make use of the SHC1300 transmitter. | |
| Some transmitters already built into other | |
| equipment may not be compatible with the | |
| SHC1300 headphone because of the advanced | |
| technologies used in the SHC1300 headphone. |
7