b.Plug the adapter into the power outlet.

c.The green LED on the front panel should be on.

Note: if it is not the case, press the ON/ OFF switch on the back of the product.

5.Check that TV1 is working well

a.Switch on TV1

b.Check that TV1 is working well.

c.Switch on the connected video source for the video source chosen.

d.Check if TV1 shows the image of the video source.

>The transmitter is connected correctly.

3.2Install the remote control blaster cord

The remote control blaster cord transmits IR signal to Source devices.

1.Switch off the transmitter (A).

2.Connect the remote control blaster cord (F) to the IR socket.

3.Position the blaster light in front of the video source. Just put it in front of the IR sensor on the front panel.

Note: See the FAQ “How can I find the IR sensor on the video source?” for locating the IR sensor on the front panel of the video source.

3.3Connect receiver

Preparation

- Switch on the transmitter (A).

10

Getting started

Page 10
Image 10
Philips SLV4200/12 manual Install the remote control blaster cord, Connect receiver