Philips SRU5060 manual Instructions for use Contents, Introduction, Installing the remote control

English

Instructions for use
	Contents
1.	Introduction	. . . . 4
2.	Installing the remote control	. . 4-7
	Inserting the batteries	. . . . 4
	Testing the remote control	. . 4-5
	Setting the remote control	. . 5-6
3.	Keys and functions	. . 7-8
4.	Extra possibilities	. 8-11
	Adjusting device selection	. . . . 8
	Adding a function to the remote control	. . . . 9
	Assign Volume control to another mode	. . . . 9
	Learn a key	. . . 10
	Restoring the original remote control settings	10-11
5.	Troubleshooting	. . . 11
6.	Need help?	. . . 12
	Code list of all brands / equipment	74-98
	Information to the Consumer	. . 101

1. Introduction

Congratulations on your purchase of the Philips SRU 5060 universal remote control. After installing the remote control you can operate a maximum of 6 different devices with it:TV, DVD player/recorder, video recorder, amplifier/receiver, CD player and STB (settop box, satellite or cable decoder). You can find information about how to prepare this remote control for use in the chapter ‘Installing the remote control’.

2. Installing the remote control

Inserting the batteries

1Press the cover inwards and slide it in the direction of the arrow.

2Place two AAA type batteries into the battery compartment, as shown.

3Slide the cover back and click it firmly into place.

Note: If the device indicators in the selector window (DVD, STB, VCR, CD and AMP)

and the Standby key blink four times after every key press, the remote control is indicating that its batteries are running low. Replace the old batteries with two new AAA batteries.

Testing the remote control

The remote control has been programmed to operate most Philips devices. Because the SRU 5060 may use different signals for each brand and even for different models of the same brand, it is advisable to test whether your device responds to the SRU 5060.The example below (TV) instructs you how to do this.You can repeat the same steps for other devices (DVD, video recorder, etc.) which you want to operate using the SRU 5060.

Example of TV:

1Turn your TV on manually or use the original remote control. Tune to channel 1.

2Press the SELECT key to select TV.

Press the key until the Standby key lights up. If the key does not light up, check whether the batteries are properly inserted

(see ‘Inserting the batteries’).

4