10.ENGLISH
Trimming Without Guide Comb
Attachment
Remove Guide Comb Attachment if you are:
◗Defining hair lines
◗Trimming nape of neck
◗Removing single, unwanted hairs
1Be certain Trimmer is in the OFF position.
C 2 | Remove the Guide Comb Attachment by |
| pulling it off the Trimmer. |
Never pull off the Guide Comb Attachment by | |
grasping the flexible top portion. Always pull off | |
by the bottom part of attachment. | |
3 | Switch the Trimmer on. |
C 4 | Make |
| the hair lightly with the Trimmer. |
Replacing Guide Comb Attachment
To Trimmer
1Be certain Trimmer is in OFF position.
2Replace Guide Comb Attachment until it “clicks” into position. The Guide Comb Attachment can be placed on Trimmer only one way. If it does not fit properly, reverse it.
ENGLISH 11.
NOTE: The Zoom Ring can be on any setting when removing or replacing Attachment.
CLEANING
◗Always switch Trimmer OFF before cleaning.
◗Do not use abrasives, scourers or liquids such as alcohol, benzene, bleach or acetone to clean the Trimmer.
◗Never clean, remove or replace Guide Comb Attachment with motor ON.
◗Do not apply pressure to cutters.
◗Do not touch cutters with hard objects as this may damage them.
◗Do not use while bathing, showering or immerse the Trimmer in water or other liquids as damage to Trimmer may occur.
During Use:
◗If cut hairs have accumulated in the Guide Comb area, pull Guide Comb Attachment off Trimmer and remove hairs by shaking and/or blowing.
Once A Week:
1Make sure the Trimmer is switched OFF and disconnected from the electrical outlet.
2 Remove the Guide Comb Attachment.
C 3 Open the cutting unit.
