2000 Feb 09 6
Philips Semiconductors Product specification
2× 25 W high efficiency car radio power
amplifier TDA1563QLIMITING VALUES
In accordance with the Absolute Maximum Rating System (IEC 134).
THERMAL CHARACTERISTICS
Note
1. The value of Rth(c-h) depends on the application (see Fig.3).
SYMBOL PARAMETER CONDITIONS MIN. MAX. UNIT
VPsupply voltage operating −18 V
non-operating −30 V
load dump; tr>2.5 ms −45 V
VP(sc) short-circuit safe voltage −18 V
Vrp reverse polarity voltage −6V
I
ORM repetitive peak output current −4A
P
tot total power dissipation −60 W
Tstg storage temperature −55 +150 °C
Tvj virtual junction temperature −150 °C
Tamb ambient temperature −40 −°C
SYMBOL PARAMETER CONDITIONS VALUE UNIT
Rth(j-c) thermal resistance from junction to case see note 1 1.3 K/W
Rth(j-a) thermal resistance from junction to ambient 40 K/W
Heatsink design
There are two parameters that determine the size of the
heatsink. The first is the rating for the virtual junction
temperatureand the second is the ambient temperature at
which the amplifier must still deliver its full power in the
BTL mode.
With a conventional BTL amplifier, the maximum power
dissipation with a music-like signal (at each amplifier) will
be approximately two times 6.5W.
Ata virtual junction temperature of 150 °C and a maximum
ambient temperature of 65 °C, Rth(vj-c) = 1.3 K/W and
Rth(c-h) = 0.2 K/W, the thermal resistance of the heatsink
should be:
Comparedto a conventional BTL amplifier, the TDA1563Q
has a higher efficiency. The thermal resistance of the
heatsink should be:
150 65–
2 6.5×
---------------------- 1.3–0.2–5 K/W=
150 65–
2 6.5×
---------------------- 1.3–0.2–5 K/W=
1.7 145 65–
2 6.5×
----------------------
1.3–0.2–9 K/W=
handbook, halfpage
3.6 K/W
0.6 K/W
3.6 K/W
virtual junction
OUT 1 OUT 1
case
3.6 K/W
0.6 K/W
3.6 K/W
OUT 2 OUT 2
MGC424
0.1 K/W
Fig.3 Thermal equivalent resistance network.