HOOKING UP YOUR TV (BASIC CABLE TV CONNECTIONS)
CABLE TV |
| SMART |
our Cable TV input into your |
| HELP |
Yhome may be a single (75 |
| Remember: |
ohm) cable, or a Converter Box |
| Set the TV for the |
installation. In either case the |
| type signal you've |
connection to the TV is very easy. |
| just connected (see |
Just put the threaded end of the |
| the “Tuner” section |
cable signal to the TV's antenna |
| on page 11 of this |
| manual.) | |
plug and screw it down tight. |
| |
|
| |
BEGIN |
| To select only the |
If your Cable TV signal is a sin- |
| |
| channel numbers on | |
gle round cable (75 ohm) then |
| your Cable system |
you're ready to connect to the TV. |
| see “Auto Program" |
If you have a Cable Converter |
| (page 12). If you use |
Box: |
| a Cable Converter |
Connect the Cable TV signal to the |
| box, set the TV to the |
Cable Signal IN(put) plug on the | 75 V | same channel as the |
Converter.. |
| converter's CH 3/4 |
Connect the Cable TV cable to the |
| switch (on the rear of |
| the converter.) | |
75 V plug on the TV. |
| |
|
| |
If you have a Cable Converter Box: |
|
|
Connect the OUT(put) plug from the |
|
|
Converter to the 75 V plug on the TV. |
|
|
Cable TV Company
Cable TV Signal Input
2
75 V
OR | Back of TV |
|
IN | OUT |
|
Round Cable
75Ω Ohm
Cable TV Converter
Box Connection
1
