Phoenix Gold RSD300.1 owner manual Controls, Indicators, And Terminals, Rca Input, RSd AMPLIFIERS

RSd AMPLIFIERS

MONOBLOCK OWNER’S MANUAL

CONTROLS, INDICATORS, AND TERMINALS:

RCA INPUT

1.AUX OUTPUT (RCA)

This output is full range and can be used to connect to another amplifier for system expansion.

2.LINE LEVEL INPUT (RCA)

To be connected to RCA pre-amp outputs from a source unit (i.e., radio, tape deck or CD player).

CONTROLS

3.REMOTE LOW PASS LEVEL CONTROL (LPL - SOLD SEPERATELY) This port is for connecting the optional LPL Remote Lowpass Level Control knob allowing up to 20dB of volume adjustment.

4.INPUT SENSITIVITY LEVEL CONTROL (SENS)

The input sensitivity level can be varied from 200 mV to 8.0 volts depending on the output voltage of the source unit (refer to sub-section titled INPUT SENSITIVITY ADJUSTMENT).

5.SUBSONIC FILTER

This is a filter to remove unwanted low frequencies that may cause damage to the speaker or are inaudible. When this is used properly it will allow the amplifier to run more effectively.

6.FREQUENCY SELECTOR (FREQ)

Allows variable adjustment from 40 to 400Hz

7.VARIABLE BASS BOOST

The bass boost will increase the output centered at 45Hz from 0 to 18dB

Phoenix Gold International, Inc. • 9300 North Decatur St. Portland, OR 97203 • 503.286.9300 • www.phoenixgold.com