Marantz SC-11S1 manual LIr··IE-··l, L Hh, 1 ~ ~, ~ N A M E S A N D F U N C T Io N S O F P A R Ts

[~_N_A_M_E_S_A_N_D_F_U_N_C_T_IO_N_S_O_F_P_'A_R_TS

( DISPLAY

J I

VOLUME Indicator Volume Display

Max

t

..... i2~. ::;

t

L HH:.-1

_. 1. .....

i....!

'_0'

Turn the VOLUME knob on the unit to the right, or press the VOLUME A button on the remote controller.

@Power Indicator

O.5dB Steps

LH~E-1

This indicator is lit a blue color while power to the unit is ON.

@Display Panel

Approximately 3 seconds after the power to the unit is activated, the ID number is displayed here.

L I r'iE-1

_. 1 ~::~ !::)

LIr··IE-··l

Min ..- U !,..!

Turn the VOLUME knob on the unit to the left, or press the VOLUME ... button on the remote controller.

After that, the top line displays the selected input source, and the bottom line displays the volume level. The volume attenuation (dB units) is displayed.

L H~E-i

The display also displays the setting values when adjusting the left-right level balance. For instructions on How to Trim Volume Level, see page. 22. Other messages that correspond to various operations are also displayed.

@OPERATE Indicator

This indicator flashes the operating status of the unit. When the ID is set to "0" for standalone operation, it is lit a red color. When multiple amplifiers are connected by F.G.B.S., only ID number "1" for the master is lit red color. The slave amplifier whose indicator does not light a red color cannot be used to operate other units in sync.

For more information on F.e.B.S., see page. 26. The indicator flashes red if a protective circuit trips.

7