Marantz SC-11S1, 642SC11S1 manual l== =c===~=== r=6= =====, I Lo, HOW TO SET 10 NUMBERS

[~_H_O_W_T_O_U_S_E_A_N_D_S_E_T_F_E_A_:r_U_R_E_S

( HOW TO SET 10 NUMBERS

If using this unit by itself as a stereo amplifier, set the 10 number to "0" (Default setting is "0").

Note:

If the 10 number is set to a number other than "0", this unit cannot be used for standalone operation.

The 10 number of the unit appears on the display for about 3 seconds after the power is activated.

I [) Lo:

::..:

When multiple SC-11 S1 s are connected, a unique 10 number must be set of each one in order to distinguish between them.

The unit that centrally controls the other units takes 10 1. The unit with 101 is called the "Master". The other units that synchronize with the master are called "slaves" and take IDs

"2" "'- "4".

---------~] I

DISPLAY button

,....-..l==;=c]===~===;;;:;r=6=;=====---,

e Q 0

L..-+'r"===J_e...l..- o ? 0---l._(:)~==T----J

INPUT SELECTOR POWER ON/OFF Switch Knob

Set 10 numbers as follows.

1.While pressing and holding the DISPLAY button, press the POWER ON/OFF switch.

I [:: :.':

::..=

2.Turn the INPUT SELECTOR knob to the desired 10 number.

T	f"-:	oj
l.	;....	.I.

After finishing setting the 10 number, turn power to the unit OFF.

The setting is stored in memory and becomes active the next time power to the unit is switched ON.

27