Marantz 642SC11S1, SC-11S1 manual ~=!==, I=-===I-e\==~r41---J, I Front Panel, I, ====r-a

II [,--N_A_M_E_S_A_N_D_F_U_N_C_TI_O_N_S_O_F_PA_R_T_S~]

I (FRONT PANEL				]
	11	10	9	8	7	6	5
		~~		(0	=::-0			"
~-..	r:::=::===I=FI- -1;;:;:;;;;;;;;;:;;;:::::::;:;:;;;:;;;;;;;;;:=;::::::::;;;:;;:;;::::;;::::::;;;;;;;;;::::;:;;;1- -I:;::I===J......""
"----	I,:====r-a----	"'~=!="=! 2			I=-===I-e""""\==~r41---J

CD POWER ON/OFF Switch

This switch turns power to the unit ON and OFF. When pressed, power is activated and the blue indicator in the display @ lights up. Pressing the switch again turns the power OFF.

en Display

Indicate the selected input source, volume level, and setting status.

®Infrared Receptor Window

This receptor window receives control signals sent from the included remote controller.

®VOLUME Knob

This knob is for setting the volume. The volume level is displayed on the display @. When turned slowly, the volume can be fine-adjusted in O.5dB steps, whereas when turned rapidly, the volume level changes greatly.

®PRE OUT Button

This buttons turns output from the PRE OUT jack and BALANCED PREOUT jack on the rear panel ON and OFF. When using just the headphones, switch this button OFF.

®PHONO MC Button

This button switches the Phono equalizer amplifier setting between MC and MM. Set the phono equalizer amplifier according to the type of cartridge you use.

(J)ATT. Button

This button attenuates the volume with one press of the button. For instructions on How to Set the Attenuation Level, see page. 21.

®Illumination Lamp

The illumination lamp casts a blue light over the switches and buttons. It can be turned ON and OFF with the DISPLAY button. For instructions on HOWTO OPERATE THE SIDE ILLUMINATION, see page. 24.

®DISPLAY Button

This button turns the display and side illumination ON and OFF. For instructions on HOW TO OPERATE THE SIDE ILLUMINATION, see page. 24.

@TONE Button

This button turns the bass and treble tone control ON and OFF. For instructions on How to Trim Bass and Treble, see page. 23. If pressed and held for 2 seconds or longer, this button switches the subsonic filter ON/OFF. For details on SUBSONIC FILTER, see page 21.

@PHONES OUT Button

This button switches the headphone jack output signal ON/OFF. Set this to OFF when not in use.

@INPUT SELECTOR Knob

This knob is for selecting the input source to use in playback and recording. The selected input source is displayed in the display @.

@PHONES Jack

This jack is for connecting headphones with a standard stereo plug.

6