PICO MACOM
Front and Rear Panels
Panels
Panels
1 | 2 | 3 | 4 | 5 6 | 7 | 8 | 9 |
PFAM 550SUB 550MHz |
|
|
|
| |||
| VIDEO | AUDIO |
| VIDEO |
|
| TEST POINT |
POWER | AUDIO | OVER | AUDIO | VIDEO OVER | CHANNEL |
|
|
| RATIO | MOD | MOD | MOD MOD | RF LEVEL |
| |
| R |
|
|
|
|
| |
|
|
|
|
|
|
|
RF OUT | IF IN | IF OUT | VIDEO | AUDIO | 250 VAC | 600VA MAX | 117VAC |
0.5A |
| 60 Hz 20 W | |||||
|
|
| IN | IN |
| ||
|
|
|
|
|
|
SUB CATV
FUSE
10 | 11 | 12 | 13 | 14 | 15 | 16 | 17 | 18 |
1.Power on LED:
Indicates power is on when lit.
2.Video/Audio Ratio adjustment: Used to set level of audio carrier.
3.Audio Modulation LED:
Indicates aural over modulation level when lit.
4.Audio Modulation adjustment:
Used to set audio modulation (Volume).
5.Video Modulation adjustment: Used to set video modulation.
6.Video modulation LED:
Indicates video
7.Channel Select:
Dip switches are used to select desired channel.
8.RF Output Adjust: Used to set output level.
9.
10.RF Output:
Connect this port to distribution system.
11.I.F. Input:
Input from I.F. scrambler or I.F. output.
12.I.F. Output:
To I.F. input or to scrambling device.
13.Video Input:
Accepts video output from satellite receiver, VCR and CCTV camera.
14.Audio Input:
Accepts audio output from satellite receiver, VCR and CCTV camera.
15.SUB CATV:
When switch is in SUB position, channels 7 to 13 are converted to T7 to T13. When switch is in CATV position, CATV channels 2 to 78 and 95 to 99 are available.
16.Fuse holder:
117VAC type - 0.5 amp, 125V
17.Convenience Outlet: 117VAC type - shown
220VAC type - 2 flat blade type (not shown)
18.Power Cord:
117VAC type - Three wire, standard U.S.A. type.
CONTACT US 858.546.5050 | www.picomacom.com |