Installation
Important
!This unit cannot be installed in a vehicle with- out ACC (accessory) position on the ignition switch.
| F | ON | ||
| F |
|
|
|
| O |
|
| S |
|
|
|
| |
|
|
|
| T |
|
|
| R | A |
|
| T |
| |
ACC position | No ACC position |
!Use this unit with a
!To prevent a
—Disconnect the negative terminal of the battery before installation.
—Secure the wiring with cable clamps or ad- hesive tape. Wrap adhesive tape around wiring that comes into contact with metal parts to protect the wiring.
—Place all cables away from moving parts, such as the gear shift and seat rails.
—Place all cables away from hot places, such as near the heater outlet.
—Do not connect the yellow cable to the bat- tery by passing it through the hole to the engine compartment.
—Cover any disconnected cable connectors with insulating tape.
—Do not shorten any cables.
—Never cut the insulation of the power cable of this unit in order to share the power with other devices. The current capacity of the cable is limited.
—Use a fuse of the rating prescribed.
—Never wire the negative speaker cable di- rectly to ground.
—Never band together negative cables of multiple speakers.
!When this unit is on, control signals are sent through the blue/white cable. Connect this cable to the system remote control of an exter- nal power amp or the vehicle’s
Section
15
na, connect it to the antenna booster power supply terminal.
!Never connect the blue/white cable to the
power terminal of an external power amp. |
| |
Also, never connect it to the power terminal of | Installation | |
the auto antenna. Doing so may result in bat- | ||
| ||
tery drain or a malfunction. |
| |
! |
| |
to connect connectors of the same color. |
|
En 61