Installation

Wired remote input

Hard-wired remote control adaptor can be connected (sold separately).

Fuse resistor

Violet/white

Of the two lead wires connected to the back lamp, connect the one in which the voltage changes when the gear shift is in the REVERSE (R) position. This connection enables the unit to sense whether the car is moving forwards or backwards.

Yellow/black

If you use an equipment with Mute function, wire this lead to the Audio Mute lead on that equipment. If not, keep the Audio Mute lead free of any connections.

Connection method

1. Clamp the lead.

2. Clamp firmly with

 

needle-nosed pliers.

Note:

·The position of the parking brake switch depends on the vehicle model. For details, consult the vehicle Owner’s Manual or dealer.

Light green

 

Parking brake

Used to detect the ON/OFF status of the parking

 

 

switch

brake. This lead must be connected to the power

Power supply side

 

supply side of the parking brake switch.

 

 

 

 

Ground side

 

Blue/white

 

 

Connect to system control terminal of the power amp or

 

auto-antenna relay control terminal (max. 300 mA 12 V DC).

 

With a 2 speaker system, do not connect anything to the speaker

 

leads that are not connected to speakers.

Note:

 

 

 

 

· Change the initial setting of this unit. The

 

subwoofer output of this unit is

 

monaural.

 

Section

15

Installation

En 65