Section |
|
|
15 | Installation |
|
| Installation | and tighten the screws at 3 or 4 locations on |
| Notes | each side. |
|
|
!Check all connections and systems before final installation.
!Do not use unauthorized parts as this may cause malfunctions.
!Consult your dealer if installation requires dril-
ling of holes or other modifications to the vehi- cle.
! Do not install this unit where:
—it may interfere with operation of the vehi- cle.
— it may cause injury to a passenger as a re- | 1 | |
sult of a sudden stop. | 2 | |
! Do not install the display where it may (i) ob- | ||
| ||
struct the driver’s vision, (ii) impair the perfor- |
| |
mance of any of the vehicle’s operating |
| |
systems or safety features, including air bags, |
| |
hazard lamp buttons or (iii) impair the driver’s |
| |
ability to safely operate the vehicle. |
| |
! The semiconductor laser will be damaged if it |
| |
overheats. Install this unit away from hot |
| |
places such as near the heater outlet. | 3 | |
! Optimum performance is obtained when the | 4 |
unit is installed at an angle of less than 30°.
!To some types of vehicles, this unit cannot be properly installed. In such case, use the op- tional installation kit
Installation using the screw holes on the side of the unit
5
1If the pawl gets in the way, bend it down.
2Factory radio mounting bracket
3Use either truss (5 mm × 8 mm) or flush surface (5 mm × 9 mm) screws, depending on the bracket screw holes.
4Frame
In some types of vehicles, discrepancy may occur between the unit and the dashboard. If this happens, use the supplied frame to fill the gap.
5Dashboard or console
%Fastening the unit to the factory radio- mounting bracket.
Position the unit so that its screw holes are aligned with the screw holes of the bracket,
68
En