Pioneer AVH-P5950DVD installation manual Max mA, 12 V DC. If the vehicle is

Note:

•This unit cannot be installed in a vehicle with- out ACC (accessory) position on the ignition switch.

		CC
	F	A	O				F	O
			N					N
O	F					O	F
					S					S
					T					T
				R	A				R	A
			T					T
ACC position						No ACC position

•Use this unit in other than the following condi- tions could result in fire or malfunction.

—Vehicles with a 12-volt battery and negative grounding.

—Speakers with 50 W (output value) and 4 ohm to 8 ohm (impedance value).

•To prevent short-circuit, overheating or malfunc- tion, be sure to follow the directions below.

—Disconnect the negative terminal of the bat- tery before installation.

—Secure the wiring with cable clamps or adhe- sive tape. To protect the wiring, wrap adhe- sive tape around them where they lie against metal parts.

—Place all cables away from moving parts, such as gear shift and seat rails.

—Place all cables away from hot places, such as near the heater outlet.

—Do not pass the yellow cable through a hole into the engine compartment to connect to a battery.

—Cover any disconnected cable connectors with insulating tape.

—Do not remove RCA caps if RCA cables are not used.

—Do not shorten any cables.

—Never cut the insulation of the power cable of this unit in order to share the power to other equipment. Current capacity of the cable is limited.

—Use a fuse of the rating prescribed.

—Never wire the speaker negative cable direct- ly to ground.

—Never band together multiple speaker’s nega-

tive cables.

• Control signal is output through blue/white cable
when this unit is powered on. Connect it to an	English
(max. 300 mA, 12 V DC). If the vehicle is
external power amp’s system remote control or
the vehicle’s auto-antenna relay control terminal
equipped with a glass antenna, connect it to the
antenna booster power supply terminal.

•Never connect blue/white cable to external power amp’s power terminal. Also, never con- nect it to the power terminal of the auto antenna. Otherwise, battery drain or malfunction may result.

•IP-BUS connectors are color-coded. Be sure to connect connectors of the same color.

•Black cable is ground. This cable and other prod- uct’s ground cable (especially, high-current prod- ucts such as power amp) must be wired separate- ly. Otherwise, fire or malfunction may result if they are accidentally detached.

•Cord function may differ according to the product, even if cord color is the same. When connecting this system, be sure to check all manuals and connect cords correctly.

Français Italiano Nederlands PyÒÒÍËÈ

2

<CRD4215-A> 3

ENG/MASTER 96 INST