Section

24Other functions

Other functions

Adjusting the response positions of the touch panels (Touch Panel Calibration)

If you feel that the touch panel keys on the screen deviate from the actual positions that respond to your touch, adjust the response positions of the touch panel. There are two adjustment methods: 4-point adjustment, in which you touch four corners of the screen; and 16-point adjustment, in which you make fine-adjustments on the entire screen.

!Park your car in a safe place and use this function. Do not operate it while driving.

!Touch the screen gently for adjustment. Forcefully pressing the touch panel may damage the touch panel. Do not use a sharp pointed tool such as a ballpoint pen or me- chanical pen. Doing so may damage the screen.

!If the touch panel cannot be adjusted prop- erly, consult your local Pioneer dealer.

1 Turn the source off.

Refer to Turning the source ON/OFF on page 8.

2Press and hold the home button to start Touch Panel Calibration.

The 4-point touch panel adjustment screen ap- pears. When 2-point appears at once, touch both.

3Touch each of the arrows on the four cor- ners of the screen.

# To cancel the adjustment, press and hold the home button.

4Press the home button to complete 4- point adjustment.

Data for the adjusted position is saved.

# Do not turn off the engine while the data is being saved.

5Press the home button to proceed to 16- point adjustment.

The 16-point touch panel adjustment screen ap- pears.

# To cancel the adjustment, press and hold the home button.

6Gently touch the center of the + mark dis- played on the screen.

After you touch all the marks, the data for the adjusted position is saved.

# Do not turn off the engine while the data is being saved.

7Press and hold the home button to com- plete the adjustment.

Using an AUX source

An auxiliary device or portable device sold separately can be connected to this unit.

About AUX connection methods

You can connect auxiliary devices to this unit.

Mini pin plug cable (AUX)

When connecting an auxiliary device using a mini plug cable

iPods and portable audio/video players can be connected to this unit via mini plug cable.

!If an iPod with video capabilities is con- nected to this unit via 3.5 mm plug (4 pole) cable (such as the CD-V150M), you can enjoy the video contents of the connected iPod.

!A portable audio/video player can be con- nected by using a 3.5 mm plug (4 pole) with an RCA cable (sold separately). However, de- pending on the cable, a reverse connection between the red (right side audio) cable and yellow (video) cable may be required in order for the sound and video image to be repro- duced correctly.

%Insert the stereo mini plug into the AUX input jack on this unit.

Refer to Connection on page 46.

Resetting the microprocessor

By pressing RESET, you can reset the microprocessor to its initial settings without changing the bookmark information.

The microprocessor must be reset in the following situations:

!Before using this unit for the first time after installation

!If the unit fails to operate properly

!When strange or incorrect messages appear on the display

1Turn the ignition switch OFF.

2Press RESET with a pen tip or other pointed instrument.

Refer to What’s what on page 7.

Note

Switch your engine ON or set the ignition switch to ACC ON before pressing RESET in the following situations:

!After completing connections

!When erasing all stored settings

!When resetting the unit to its initial (factory) set- tings

44En