Section

25Connection

Connecting the power cord

 

26 pin cable (Supplied with navigation unit)

Pioneer Add-on

Insert the 26 pin cable in the direction

Navigation system

indicated in the figure.

RGB input

(sold separately)

 

 

 

 

 

Please contact your dealer to

 

This product

 

 

Antenna input

 

inquire about the connectable

 

 

 

navigation unit.

 

 

 

 

 

Fuse (10 A)

 

 

 

AUX jack (3.5 ø)

 

 

 

Use a mini plug cable to connect with auxiliary

 

 

device.

 

Yellow

Connect to the constant 12 V supply terminal.

Orange/white

Connect to lighting switch terminal.

Red

Connect to terminal controlled by ignition switch (12 V DC).

Black (chassis ground)

Connect to a clean, paint-free metal location.

 

 

White

Gray

 

 

Front speaker

 

White/black

Gray/black

 

Front speaker

 

 

Left

 

 

Right

 

 

 

 

 

 

 

 

Green

Violet

 

 

Rear speaker or

 

 

 

 

Rear speaker or

Subwoofer (4 Ω)

 

Green/black

Violet/black

 

Subwoofer (4 Ω)

 

 

 

 

 

 

 

 

 

 

 

 

When using a subwoofer of 70 W (2 Ω), be sure to connect with Violet and Violet/black leads of this unit. Do not connect anything to Green and Green/black leads.

Green

Violet

Not used.

 

 

Subwoofer (4 Ω)

 

 

 

 

 

× 2

Green/black

Violet/black

 

 

 

 

Connection

4 m (13 ft. 1 in.)

Microphone

 

(Function of AVH-X5500BHS/AVH-X4500BT/AVH-X3500BHS/AVH-X2500BT)

Microphone input

(Function of AVH-X5500BHS/AVH-X4500BT/AVH-X3500BHS/AVH-X2500BT)

Wired remote input

Hard-wired remote control adapter can be connected (sold separately).

Violet/white

Of the two lead wires connected to the back lamp, connect the one in which the voltage changes when the gear shift is in the REVERSE (R) position. This connection enables the unit to sense whether the car is moving forwards or backwards.

Yellow/black

If you use an equipment with Mute function, wire this lead to the Audio Mute lead on that equipment. If not, keep the Audio Mute lead free of any connections.

Connection method

1. Clamp the lead.

2. Clamp firmly with

 

needle-nosed pliers.

Note:

·The position of the parking brake switch depends on the vehicle model. For details, consult the vehicle Owner’s Manual or dealer.

Light green

 

 

Used to detect the ON/OFF status of the parking

 

Parking brake

brake. This lead must be connected to the power

Power supply side

switch

supply side of the parking brake switch.

 

 

 

Ground side

 

Blue/white

 

 

Connect to system control terminal of the power amp or

 

 

auto-antenna relay control terminal (max. 300 mA 12 V DC).

 

With a 2 speaker system, do not connect anything to the speaker leads

 

that are not connected to speakers.

Note:

 

 

 

 

· Change the initial setting of this unit. The

 

subwoofer output of this unit is monaural.

46En