Connection | Connection |
Section
25
WARNING
!In some countries or states the viewing of images on a display inside a vehicle even by persons other than the driver may be illegal. Where such regulations apply, they must be obeyed and this unit’s DVD features should not be used.
CAUTION
!Do not drill a hole into the engine compart- ment to connect the yellow cable of the dis- play unit to the vehicle battery. Engine vibration may eventually cause the insulation to fail at the point where the wire passes from the passenger compartment into the engine compartment. Take extra care in se- curing the wire at this point.
!Make sure that cables will not interfere with moving parts of the vehicle, such as the shift lever, parking brake or seat sliding mecha- nism.
WARNING
!Use speakers over 50 W (output value) and between 4 W to 8 W (impedance value). Do not use 1 W to 3 W speakers for this unit.
!The black cable is ground. When installing this unit or power amp (sold separately), make sure to connect the ground wire first. Make sure that the ground cable is properly connected to metal parts of the car body using a spade terminal sold commercially. The ground wire of the power amp and the one of this unit or any other device must be connected to the car separately with different screws. If the screw for the ground wire loos- ens or falls out, it could result in fire, genera- tion of smoke or malfunction.
Ground wire | POWER AMP | ||
|
|
|
|
|
|
|
|
Other devices | Metal parts of car’s body | |
(Another electronic | ||
| ||
device in the car) |
|
Important
!This unit cannot be installed in a vehicle without ACC (accessory) position on the igni- tion switch.
| F | ON | |
| F |
|
|
| O |
| S |
|
|
| T |
|
| TR | A |
|
|
| |
ACC position | No ACC position | ||
!Use this unit with a
!To prevent a
—Disconnect the negative terminal of the bat- tery before installation.
—Secure the wiring with cable clamps or adhe- sive tape. Wrap adhesive tape around wiring that comes into contact with metal parts to protect the wiring.
—Place all cables away from moving parts, such as the shift lever and seat rails.
—Place all cables away from hot places, such as near the heater outlet.
—Do not connect the yellow cable to the battery by passing it through the hole to the engine compartment.
—Cover any disconnected cable connectors with insulating tape.
—Do not shorten any cables.
—Never cut the insulation of the power cable of this unit in order to share the power with other devices. The current capacity of the cable is limited.
—Use a fuse of the rating prescribed.
—Never wire the negative speaker cable directly to ground.
—Never band together negative cables of multi- ple speakers.
!When this unit is on, control signals are sent through the blue/white cable. Connect this cable to the system remote control of an ex- ternal power amp or the vehicle’s
12 V DC). If the vehicle is equipped with a glass antenna, connect it to the antenna booster power supply terminal.
!Never connect the blue/white cable to the power terminal of an external power amp. Also, never connect it to the power terminal of the auto antenna. Doing so may result in battery drain or a malfunction.
English
En 45