Pioneer AVIC-Z3 About liquid crystal display LCD screen, Keeping the LCD screen in good condition

Models: AVIC-Z3

1 24
Download 24 pages 24.03 Kb
Page 21
Image 21
About liquid crystal display (LCD) screen

When the LCD panel is subjected to direct sun- light for a long period of time, it will become very hot, resulting in possible damage to the LCD screen. When not using this navigation system, avoid exposing it to direct sunlight as much as possible.

The LCD panel should be used within the tem- perature ranges shown below.

Operating temperature range:

+14 °F to +122 °F

Storage temperature range: –4 °F to +176 °F

Do not use the LCD panel at temperatures higher or lower than the operating temperature range because the LCD panel may not operate normally and the LCD panel can be damaged.

The LCD screen is exposed in order to increase its visibility within the vehicle. Please do not press strongly on it as this may damage it.

Do not place anything on the LCD panel when it is opened. Also, do not attempt to manually adjust the angle or open/close the LCD panel. Applying strong force to the LCD panel may damage it.

Do not push on the LCD screen with a large amount of force as this may scratch it.

Never touch the LCD screen with anything besides your finger when operating the Touch Panel functions. The LCD screen can scratch easily. (The stylus is supplied for special cali- brations. Do not use the stylus for normal oper- ation.)

Be careful not to place anything between the LCD panel and the main body when the LCD panel is closing. If an object gets between the LCD panel and main body, the LCD panel may stop working.

About liquid crystal display (LCD) screen

If the LCD panel is near the vent of an air con- ditioner when it is opened, make sure that air from the air conditioner is not directly blowing on the panel. Heat from the heater may break the LCD screen, and cool air from the air con- ditioner may cause moisture to form inside the product, resulting in possible damage. Also, if the LCD panel is cooled down by the air condi- tioner, the LCD screen may become dark, or the life span of the small fluorescent tube used inside the LCD panel may be shortened.

Small black dots or white dots (bright dots) may appear on the LCD screen. These are due to the characteristics of the LCD screen and do not indicate a problem with the navigation sys- tem.

At low temperatures, the LCD screen may be dark for a while after the power is turned on.

The LCD screen will be difficult to see if it is exposed to direct sunlight.

When using a cellular phone, keep the antenna of the cellular phone away from the navigation system to prevent video disruption with disturbances such as spots or colored stripes.

Keeping the LCD screen in good condition

When removing dust from the LCD screen or cleaning the LCD screen, first turn the system power off, then wipe with a soft dry cloth.

When wiping the LCD screen, take care not to scratch the surface. Do not use harsh or abra- sive chemical cleaners.

About small fluorescent tube

A small fluorescent tube is used inside the dis- play to illuminate the LCD screen.

The fluorescent tube should last for approx- imately 10 000 hours, depending on operat- ing conditions. (Using the navigation system at low temperatures reduces the service life of the fluorescent tube.)

When the fluorescent tube reaches the end of its life, the LCD screen will be dark and the image will no longer be projected. If this happens, consult your dealer or the nearest authorized Pioneer Service Station.

Appendix

19

Page 21
Image 21
Pioneer AVIC-Z3 manual About liquid crystal display LCD screen, Keeping the LCD screen in good condition