Pioneer CDJ-900 Rear Panel, Front Panel

DRB1486-A
En
10
p JOG MODE, VINYL mode indicator and CDJ mode indicator
(page 18)
The mode switches between VINYL and CDJ each time this is pressed. The
indicator lights when the VINYL mode is selected.
q SLIP (page 18)
r TEMPO ±6/±10/±16/WIDE (page 15)
s MASTER TEMPO (page 15)
t TEMPO (page 15)
u Jog dial (– REV/
+ FWD) (page 17)
v Jog dial display section (page 11)
Rear Panel
w POWER ON OFF
Press to turn the power on and off.
x AUDIO OUT L/ R (page 12)
y AC IN (page 12)
z CONTROL (page 18)
A Kensington security slot
B DIGITAL OUT
C LINK (page 12)
D USB (page 12)
Front Panel
E Disc insertion slot
F Disc force eject pin insertion hole
About ejecting discs by force
 If the disc cannot be ejected by pressing [DISC EJECT], the disc can be
ejected forcibly by inserting the disc force eject pin all the way into the disc
force eject pin insertion hole on the main unit’s front panel.
 When forcibly ejecting a disc, be sure to do so following the procedure below.
1 Press [POWER] and wait at least 1 minute after the set’s
power has turned off.
Never forcibly eject a disc directly after turning off the set’s power. Doing so is
dangerous for the reasons described below.
The disc will still be spinning when ejected and could hit your fingers, etc.,
causing injury.
Also, the disc clamp will rotate in an unstable way, and the disc could get
scratched.
2 Use the included disc force eject pin. (Do not use anything
else.)
The included disc force eject pin is mounted on the CDJ-900’s bottom panel.
When the pin is inserted all the way into the insertion hole, the disc is ejected 5
mm to 10 mm out of the disc insertion slot. Grasp the disc with your fingers and
pull it out.