Listening to the radio
3
1
2
5
4
These are the basic steps necessary to operate
the radio. More advanced tuner operation is
explained starting on the next page.
1Stereo (5) indicator
Shows that the frequency selected is being
broadcast in stereo.
2Preset number indicator
Shows what preset has been selected.
3Frequency indicator
Shows to which frequency the tuner is
tuned.
4Signal level indicator
Shows the radio wave strength.
5Band indicator
Shows which band the radio is tuned to, AM
or FM.
1 Press SOURCE to select the tuner.
Press SOURCE until you see TUNER dis-
played.
2 Use VOLUME to adjust the sound level.
Rotate to increase or decrease the volume.
3 Press BAND to select a band.
Press BAND until the desired band is dis-
played, F1,F2,F3 for FM or AM.
4 To perform manual tuning, press cor
dwith quick presses.
The frequencies move up or down step by
step.
5 To perform seek tuning, press and hold
cor dfor about one second and release.
The tuner will scan the frequencies until a
broadcast strong enough for good reception is
found.
#You can cancel seek tuning by pressing either
cor dwith a quick press.
#If you press and hold cor dyou can skip
broadcasting stations. Seek tuning starts as soon
as you release the buttons.
Note
When the frequency selected is being broadcast
in stereo the stereo (5) indicator will light.
Tuner
En
12
Section
04