#If the subwoofer setting has been previously
adjusted, the frequency of that previously se-
lected will be displayed instead of 80.
2 Press cor dto select cut-off frequency.
Press cand 50 (Hz) is displayed. Press dand
125 (Hz) is displayed. Only frequencies lower
than those in the selected range are output
from the subwoofer.
3 Press aor bto adjust the output level
of the subwoofer.
Each press of aor bincreases or decreases
the level of the subwoofer (e.g., +6 to 6).
Press aor buntil you see the desired value
displayed.

Using non fading output

When the non fading output setting is on, the
audio signal does not pass through this units
low pass filter (for the subwoofer), but is out-
put through the RCA output.
1 Press AUDIO to select non fading out-
put on/off setting.
When the subwoofer controller setting is only
P/O :FUL, you can switch to the non fading
output on/off setting. (Refer to page 34.)
Press AUDIO until NOFAD:ON appears in the
display.
2 Press ato turn non fading output on.
NOFAD:ON appears in the display. Non fading
output is now on.
#To turn non fading output off, press b.

Adjusting non fading output level

When the non fading output is on, you can ad-
just the level of non fading output.
1 Press AUDIO to select non fading out-
put setting.
Press AUDIO until NOFAD: 0 appears in the
display.
2 Press aor bto adjust the output level
of the non fading.
Each press of aor bincreases or decreases
the level of the non fading (e.g., +6 to 6).
Press aor buntil you see the desired value
displayed.

Using the high pass filter

When you do not want low sounds from the
subwoofer output frequency range to play
from the front or rear speakers, turn the HPF
(high pass filter) on. Only frequencies higher
than those in the selected range are output
from the front or rear speakers.
1 Press AUDIO to select HPF.
Press AUDIO until HPF appears in the display.
2 Press ato turn high pass filter on.
HPF : 80 appears in the display. High pass fil-
ter is now on.
#If the high pass filter has been previously ad-
justed, the frequency of that previously selected
will be displayed instead of HPF : 80.
#To turn high pass filter off, press b.
3 Press cor dto select a high pass filter
range.
Press cand HPF : 50 is displayed. Press d
and HPF :125 is displayed. Only frequencies
higher than those in the selected range are
output from the front or rear speakers.
Audio Adjustments
En 31
English
Section
07