Connecting the Units | <ENGLISH> |
Installation | <ENGLISH> |
7When using a Subwoofer without using the optional amplifier
(Blue)
Rear output
This product | 15 cm |
Front output
Subwoofer output |
|
| |
|
| Jack for the Wired Remote Control Adaptors | |
Antenna jack | Fuse (10 A) | Please see the Instruction Manual for the | |
Wired Remote Control Adaptors (sold separately). | |||
|
|
Note:
• Before making a final installation of the unit, tem- |
porarily connect the wiring to confirm that the con- |
nections are correct and the system works |
properly. |
• Use only the parts included with the unit to ensure |
proper installation. The use of unauthorized parts |
can cause malfunctions. |
• Consult with your nearest dealer if installation |
requires the drilling of holes or other modifications |
of the vehicle. |
• Install the unit where it does not get in the driver’s |
way and cannot injure the passenger if there is a |
sudden stop, like an emergency stop. |
• The semiconductor laser will be damaged if it |
•If installation angle exceeds 60° from horizontal, the unit might not give its optimum performance. (Fig. 4)
60°
Removing the unit (Fig. 6) (Fig. 7)
Frame
To remove the frame, extend top and bottom of the frame outwards in order to unlock it. (When reattaching the frame, point the side with a groove downwards and attach it.)
•It becomes easy to remove the frame if the front panel is released.
(sold separately) |
overheats, so don’t install the unit anywhere hot |
— for instance, near a heater outlet. |
Fig. 4
Fig. 6
Yellow/black
If you use an equipment with Mute function, wire this lead to the Audio Mute lead on that equipment. If not, keep the Audio Mute lead free of any connections.
Yellow
Blue/white
To system control terminal of the power amp or
DIN Front/Rear-mount
This unit can be properly installed either from “Front” (conventional DIN
DIN Front-mount
Insert the supplied extraction keys into the unit, as shown in the figure, until they click into place. Keeping the keys pressed against the sides of the unit, pull the unit out.
To terminal always supplied with power regardless of ignition switch position.
Red
To electric terminal controlled by ignition switch (12 V DC) ON/OFF.
Orange/white
To lighting switch terminal.
White | Gray | + |
+ |
| |
Front speaker |
|
|
≠ | Gray/black | ≠ |
White/black |
| |
Left |
|
|
Front speaker
Right
Installation with the rubber bush (Fig. 5)
Dashboard
182
Holder
After inserting the holder into the dashboard, then select the appropriate tabs according to the thickness of the dashboard material and bend them. (Install as firmly as possible using the top and bottom tabs. To secure, bend the tabs 90 degrees.)
Fig. 7
Black (ground)
To vehicle (metal) body.
+ | Green | Violet | + |
|
| ||
Subwoofer |
|
|
|
≠ | Green/black | Violet/black | ≠ |
|
|
Subwoofer
53
Rubber bush
Screw
Note:
Change the initial setting of this unit (refer to the Operation
Manual). The subwoofer output of this unit is monaural.
Fig. 3
Fig. 5