Installation
DIN Rear-mount
Installation using the screw holes on the side of the unit
1. Remove the frame. (Fig. 8)
<ENGLISH>
Fixing the front panel
If you do not operate the removing and attaching the front panel function, use the supplied fixing screws and holders to fix the front panel to this unit.
1. Attach the holders to both sides of the front panel. (Fig. 11)
Frame
To remove the frame, extend top and bottom of the frame outwards in order to unlock it. (When reattaching the frame, point the side with a groove downwards and attach it.)
•It becomes easy to remove the frame if the front panel is released.
Fig. 8
2.Fastening the unit to the factory radio mounting bracket. (Fig. 9) (Fig. 10)
Fig. 11
2. Replace the front panel to the unit. (Fig. 12)
Select a position where the screw holes of the bracket and the screw holes of the head unit become aligned (are fitted), and tighten the screws at 2 places on each side. Use either truss screws (5 ⋅ 8 mm) or flush surface screws
(5 ⋅ 9 mm), depending on the shape of the screw holes in the bracket.
Fig. 12
3. Flip the holders into upright positions. (Fig. 13)
Fig. 9
Fig. 13
Screw
4. Fix the front panel to the unit using fixing screws. (Fig. 14)
Dashboard or Console
Fixing screw
Factory radio mounting bracket | Fig. 14 |
Fig. 10
