Contents

 

Connecting the units

2

Connecting the power cord

4

When using a subwoofer

 

without using the optional amplifier

6

When connecting to

 

separately sold power amp

8

When connecting speakers

 

without using the internal amplifier

10

Installation

12

DIN Front/Rear-mount

12

Removing or attaching the trim ring

12

DIN Front-mount

13

DIN Rear-mount

13

Fastening the front panel

14

Installing the microphone

14

When installing the microphone

 

on the sun visor

14

When installing the microphone

 

on the steering column

15

Adjusting the microphone angle

15

Installing the steering remote control

15

Installing the unit on a left-hand drive car

16

Connecting the units

Note

When this unit is installed in a vehicle without ACC (accessory) position on the ignition switch, red cable must be wired to the terminal that can detect the operation of the ignition key. Otherwise, battery drain may result.

 

 

CC

 

 

 

 

 

 

 

F

A

O

 

 

F

O

 

 

 

N

 

N

O

F

 

 

 

O

F

 

 

 

 

S

 

S

 

 

 

 

 

 

 

 

 

T

 

 

 

T

 

 

 

R

A

 

 

R

A

 

 

 

 

 

 

 

 

 

 

T

 

 

 

T

 

ACC position

No ACC position

Use this unit in other than the following conditions could result in fire or malfunction.

Vehicles with a 12-volt battery and negative grounding.

Speakers with 50 W (output value) and 4 ohm to 8 ohm (impedance value).

To prevent short-circuit, overheating or malfunction, be sure to follow the directions below.

Disconnect the negative terminal of the battery before installation.

Secure the wiring with cable clamps or adhesive tape. To protect the wiring, wrap adhesive tape around them where they lie against metal parts.

Place all cables away from moving parts, such as gear shift and seat rails.

Place all cables away from hot places, such as near the heater outlet.

Do not pass the yellow cable through a hole into the engine compartment to connect to a battery.

Cover any disconnected cable connectors with insulating tape.

Do not shorten any cables.

Never cut the insulation of the power cable of this unit in order to share the power to other equipment. Current capacity of the cable is limited.

Use a fuse of the rating prescribed.

Never wire the speaker negative cable directly to ground.

Never band together multiple speaker’s

negative cables.



Page 2
Image 2
Pioneer DEH-P710BT installation manual Contents