Installation
Note:
•Before making a final installation of the unit, tem- porarily connect the wiring to confirm that the con- nections are correct and the system works properly.
•Use only the parts included with the unit to ensure proper installation. The use of unauthorized parts can cause malfunctions.
•Consult with your nearest dealer if installation requires the drilling of holes or other modifications of the vehicle.
•Install the unit where it does not get in the driver’s way and cannot injure the passenger if there is a sudden stop, like an emergency stop.
•The semiconductor laser will be damaged if it overheats, so don’t install the unit anywhere hot
— for instance, near a heater outlet.
Removing the unit (Fig. 5) (Fig. 6)
•If installation angle exceeds 60° from horizontal, the unit might not give its optimum performance. (Fig. 3)
60°
Fig. 3
Frame
To remove the frame, extend top and bottom of the frame outwards in order to unlock it. (When reattaching the frame, point the side with a groove downwards and attach it.)
•It becomes easy to remove the frame if the front panel is released.
Fig. 5
DIN Rear-mount
Installation using the screw holes on the side of the unit
1. Remove the frame. (Fig. 7)
Frame
To remove the frame, extend top and bottom of the frame outwards in order to unlock it. (When reattaching the frame, point the side with a groove downwards and attach it.)
• It becomes easy to remove the
<ENGLISH>
Fixing the front panel
If you do not operate the removing and attaching the front panel function, use the supplied fixing screw to fix the front panel to this unit.
Fixing screw
DIN Front/Rear-mount
This unit can be properly installed either from “Front” (conventional DIN
DIN Front-mount
Insert the supplied extraction keys into the unit, as shown in the figure, until they click into place. Keeping the keys pressed against the sides of the unit, pull the unit out.
frame if the front panel is released.
Fig. 7
2.Fastening the unit to the factory radio mounting bracket. (Fig. 8) (Fig. 9)
Select a position where the screw holes of the bracket and the screw holes of the head unit become aligned (are fitted), and tighten the screws at 2 places on each side. Use either truss screws (5 ⋅ 8 mm) or flush surface screws
Fig. 10
Dashboard
182
Holder
After inserting the holder into the dashboard, then select the appropriate tabs according to the thickness of the dashboard material and bend them. (Install as firmly as possible using the top and bottom tabs. To secure, bend the tabs 90 degrees.)
Fig. 6
(5 ⋅ 9 mm), depending on the shape of the screw holes in the bracket.
Fig. 8
53
Rubber bush
Screw
Screw
Dashboard or Console
Factory radio mounting bracket
Fig. 4 | Fig. 9 |
|
